Sentry Smart CDU Online Demo

This Server Technology Sentry Smart CDU Online Demo runs off the Sentry model CS-48VD1-C20, a Zero-U vertically mounted CDU with 48 outlets, powered by two 110 V input power feeds. The total input load for each power feed is displayed under the Environmental Monitoring screens as well as the temperature/humidity from the two external probes.

Features of the Smart CDU Products     

• Easy to use and access, secure, integral HTML Web GUI over HTTP/S, plus LDAP/S and TACACS+ external authentication and authorization support 
• Optional temperature and humidity probes with 10-ft cords to allow sensors to be located in different locations
• True RMS input current monitor(s) on easy-to-read local LED, via network or serial connection
• SNMP traps provide automated alerts for power and environmental conditions.  Additionally, event notification is available via Syslog and email
• 3 Phase products have a seperate LED for each phase to simplify load balancing 
• Branch Circuit Protection – meetings UL 60950-1 
• Available in 120/208/230/400V, 16A/20/30/32/60A, single-phase and 3-phase

 

Web Interface Demo

»Click here to begin HTML Demo
At the authentication page, enter the following:
Username: admn
Password: admn
Click on 'OK'
To logout, click on the link located in the navigation bar on the left of the screen.    

Product evaluation checklist

In order to maximize the demo and fully understand all the features of the Smart Products check out the CS product evaluation checklist    

Telnet Connection Demo Web Interface Demo

To start the Telnet demo click on the link located below. This will load the Telnet application on your system.
»Click here to begin Telnet Demo
At the authentication page, enter the following:
Username: admn
Password: admn
Press 'Enter'

Because the Telnet applications differ between operating systems, these instructions are designed to cover the basic operations required to make this demo operate properly.  General recommendations for all Telnet applications include having the Terminal Preferences set to VT-100/ANSI emulation and VT 100 Arrows.

To get a display of available commands, just press Enter at the 'Smart' prompt, which will show: 

Smart CDU Commands are:

ON	OFF	REBOOT	STATUS	UPSTAT	VERSION	CREATE	SHOW
REMOVE	LOGIN	SET	ADD	DELETE	LIST	PASSWORD	SYSSTAT
ISTAT	ENVMON	LOGOUT	RESTART	PING	CONNECT

 

 

To view the status of all the outlets, type 'status' at the 'Sentry' prompt. 
To view the temperature and humidity, type 'envmon' at the 'Smart CDU' prompt.
To end a session type LOGOUT and press Enter.

Please note that changes made during the demo session may NOT be preserved when the session is ended.