Remote Power Reboot Switch RPS-10M HD Code Controlled, Expandable, Heavy Duty (Master Module 115 VAC)

Remote Power Reboot Switch RPS-10M HD Code Controlled, Expandable, Heavy Duty (Master Module 115 VAC)
  • RPS-10
  • Detail
  • Mounted View
  • Rear View
  • Diagram

Remote Power Reboot Switch RPS-10M HD Code Controlled, Expandable, Heavy Duty (Master Module 115 VAC)

RPS-10MHD
  • Overview
  • Download

Applications:

  • Remote Control of Large Servers
  • Switch up to 15 Amps @ 115VAC
  • Reboot CNC or Robotics Equipment
  • Control Remote Climate Control Equipment
  • Attention Red Hat Cluster Manager Users
  • PDF Format Spec Sheet (208 Kb)

Features:

  • Expandable Master-Satellite Configuration
  • End-to-End Link Distance of 2,000 Feet
  • RS-232 Control via Modem or Terminal Server
  • 115 VAC, 10 Amp Model Also Available
  • 230 VAC, 5 Amp Model Also Available

Network equipment sometimes "locks-up", requiring a trip to flip the power switch off and then back on. This can be done remotely, and with the Heavy Duty version of the Western Telematic's Remote Power Switch, it can be done on any device that does not exceed 15 Amps.

The RPS-10-HD works like the other light duty units. It is controlled by a password and control string that tells the unit to remove the power temporarily to reboot a device or turn it off until it is turned back on again.

The RPS-10-HD can be rack-mounted or distributed throughout the facility for better control of 115 VAC equipment. A status report will even provide the system operator with the status of each switch.

General Specifications:

  • RPS-10M-HD:  Remote Power Switch, Master Unit - 15 Amps 115 VAC
  • RPS-10S-HD:  Remote Power Switch, Satellite Unit - 15 Amps 115 VAC
  • Switched Outlet:  1 Plug, Rated at 15 Amps Max @115 VAC
  • Control Port:  RS-232, DB9M Connector, AT/DTE Configuration (Only on the Master Unit)
  • Link Port:  RS-485, Dual RJ11 Jacks, 2000 Feet End-to-End Distance
  • Data Rate:  2400, 9600 bps (Switch Selectable)
  • Power:  Internal 115 VAC, 60 Hz -15 Amps Max. Load per Module
  • Size:  1.65" X 5.50" X 5.0" (H x W x D)
  • Rack Tray Optional:  19" Rack Holds up to 3 Modules
  • Weight:  2 Lbs. Shipping Weight

Attention Red Hat Cluster Manager Users

For users of Red Hat Cluster Managers, the following items are recommended for implementation of the power management portion of the cluster:

  • RPS-10M-HD - 115 VAC Power Switch, 2 Each
    or
  • RPS-10M-EC - 230 VAC Europe Approved Power Switch, 2 Each
    Red Hat Cluster Manager documentation also recommends the WTI NPS-115 or NPS-230 for network-enabled power control. Please see Red Hat Supplementary Hardware Information for further details.
  • NC-9F9F - 9-Pin to 9-Pin Serial Cable, 2 Each
  • RPS-10R - 19 Inch Rack Tray, 1 Each, (Optional)